Device : Xiaomi Redmi Note 8
Operation : Reset Mi Account
Checking for existing devices…Found
Port : Qualcomm HS-USB QDLoader 9008 (COM19)
Driver Info : Qualcomm Incorporated, qcusbser.sys, 5.1.1.2
Opening Port…OK
Init Handshake Sequence…OK
Hardware ID : E1A01000 [SDM665] 00007200
OPK_DATA : 4B60244704D721E5B96DD5BB7233886E38F2198FBDE6433FCE1D25A7B0472DD7
Initializing Protocol…OK
Using Auto Loader Selection [1]
Preparing Loader…Done
Sending Loader [SDM665]…Done
Executing Loader…OK
Detecting Chip Type…OK
Hardware : SDM665, eMMC, 64 GB
LU Count : 1 [0x0747C000]
WARNING! High Speed Driver is not installed.
Please install driver from QcFire\Drivers folder using Device Manager.
Payload Info : In: 65536 [65536], Out: 16384, Sector Size: 512
Reading Partition Table…OK
Reading Device Information…OK
Device : Xiaomi Redmi Note 8 [ginkgo]
Brand : xiaomi
Prod.Name : ginkgo
Software : PKQ1.190616.001, V11.0.9.0.PCOMIXM [Mon Jun 1 11:37:49 WIB 2020]
Android Ver. : 9
Patch Level : 2020-05-01
Resetting Mi Account Data…Done
Preparing Data…Done
Formatting Userdata…Done
When phone is completely ON, connect to Internet and add Mi Account.
————– INFORMATION ————–
New Firmware may cause hang on logo.
In such case, you need to flash phone to recover.
Or downgrade firmware and try Reset Mi Account again.
Operation Finished.
QcFire Ver. 6.3